Question 1

How many units is 5 mg of tirzepatide?

Accepted Answer

It depends on your vial concentration. With a 10 mg/mL vial, 5 mg equals 50 units. With a 20 mg/mL vial, it equals 25 units. With a 30 mg/mL vial, it equals approximately 17 units. Always check your vial label and apply the formula: units = (dose in mg / concentration in mg per mL) x 100.

Question 2

How do I convert tirzepatide units to milligrams?

Accepted Answer

Multiply the number of syringe units by the vial concentration in mg/mL, then divide by 100. For example, 25 units drawn from a 20 mg/mL vial delivers 5 mg of tirzepatide (25 x 20 / 100 = 5 mg). This reverse calculation lets you verify your drawn dose before injecting.

Question 3

What concentrations does compounded tirzepatide come in?

Accepted Answer

Common compounded tirzepatide concentrations are 5 mg/mL, 10 mg/mL, 20 mg/mL, and 30 mg/mL. Higher concentrations are more common for tirzepatide than semaglutide because the prescribed milligram doses are larger. Your pharmacy label will state the exact concentration — always check it before drawing.

Question 4

What is the tirzepatide dosage chart for a 10 mg/mL vial?

Accepted Answer

For a 10 mg/mL compounded vial: 2.5 mg = 25 units, 5 mg = 50 units, 7.5 mg = 75 units, and 10 mg = 100 units (a full 1 mL syringe). Doses above 10 mg at this concentration would exceed a standard 1 mL syringe, so higher-concentration vials (20 or 30 mg/mL) are typically used for doses of 12.5 mg and 15 mg.

Question 5

How do I draw compounded tirzepatide from a vial?

Accepted Answer

Use a new, sterile U-100 insulin syringe. Clean the vial stopper with an alcohol swab. Draw air into the syringe equal to the needed volume, inject air into the vial, invert, and pull the plunger to the correct unit mark. Remove bubbles by tapping and gently pushing the plunger. Verify the unit count matches your prescribed dose before withdrawing the needle.

Question 6

How many units is 10 mg of tirzepatide in a 20 mg/mL vial?

Accepted Answer

50 units. The calculation: 10 mg divided by 20 mg/mL equals 0.50 mL, and 0.50 mL on a U-100 syringe is 50 units. This is a common mid-range maintenance dose and keeps the injection volume to half a milliliter — comfortable for subcutaneous administration.

Question 7

Is the dosing the same for Mounjaro and Zepbound?

Accepted Answer

Yes, both Mounjaro and Zepbound contain tirzepatide and use the same dose escalation schedule from 2.5 mg to 15 mg weekly. Mounjaro is approved for type 2 diabetes and Zepbound for weight management, but the active ingredient, dose strengths, and pen design are identical. Compounded tirzepatide follows the same escalation under provider guidance.

Question 8

Why do tirzepatide vials come in higher concentrations than semaglutide?

Accepted Answer

Tirzepatide maintenance doses (up to 15 mg) are much larger than semaglutide maintenance doses (up to 2.4 mg). Without higher concentrations, the injection volume would be uncomfortably large. A 15 mg dose at 30 mg/mL is just 50 units (0.5 mL), whereas at 5 mg/mL it would be 300 units (3 mL) — far too much for a standard insulin syringe.

Question 9

How many doses can I get from one tirzepatide vial?

Accepted Answer

It depends on vial volume, concentration, and your weekly dose. A 5 mL vial at 10 mg/mL contains 50 mg total. At 2.5 mg weekly, that is 20 doses. At 5 mg weekly, 10 doses. At 10 mg weekly, 5 doses. Check your vial label for total volume and concentration, then divide total mg by your weekly dose to calculate how many weeks the vial will last.

Question 10

Can I use a tirzepatide injection units calculator for any vial concentration?

Accepted Answer

Yes. Our calculator accepts any concentration in mg/mL and any prescribed dose in mg. Whether your compounding pharmacy provides 5, 10, 20, 30, or any custom concentration, the calculator applies the standard formula (dose / concentration x 100) to give you the correct U-100 syringe unit count.

Dose	5 mg/mL	10 mg/mL	15 mg/mL	25 mg/mL	30 mg/mL	60 mg/mL	90 mg/mL	100 mg/mL
2.5 mg	50	25	16.7	10	8.3	4.2	2.8	2.5
5 mg	100*	50	33.3	20	16.7	8.3	5.6	5
7.5 mg	150*	75*	50	30	25	12.5	8.3	7.5
10 mg	200*	100*	66.7*	40	33.3	16.7	11.1	10
12.5 mg	250*	125*	83.3*	50	41.7	20.8	13.9	12.5
15 mg	300*	150*	100*	60*	50	25	16.7	15

Weeks	Dose	Phase
1-4	2.5 mg	Initiation
5-8	5 mg	Escalation
9-12	7.5 mg	Escalation
13-16	10 mg	Escalation
17-20	12.5 mg	Escalation
21+	15 mg	Maintenance

Weeks	Dose	Phase
1-4	2.5 mg	Initiation
5-8	5 mg	Escalation
9-12	7.5 mg	Escalation
13-16	10 mg	Escalation
17-20	12.5 mg	Escalation
21+	15 mg	Maintenance

Tirzepatide Dosage Calculator

Quick Reference Table

Tired of calculating doses?

Brand Pen Schedules

Mounjaro

Zepbound

Frequently Asked Questions

Related Pages

Dose-Specific Calculators

Other Calculators

Dosage Guides

All Dosage Calculators

Ready to Get Started?